First make sure the clients are reporting to your server (should have asked you the IP address when you compiled the clients.
As for hobbit-clients you can do the configurations for each server if you wish by using the following:
HOST=host1, host2
DISK 90 95
PROC ccApp.exe 1
MEMPHYS 99 100
HOST=host3
DISK 80 90
DEFAULT
UP 1h
LOAD 5.0 10.0
DISK %^(/vob|/cdrom).* IGNORE
DISK %^/(mnt|tap).* IGNORE
DISK * 90 95
MEMPHYS 100 101
MEMSWAP 50 80
MEMACT 90 97
▸ quoted from Christian Rehberger
-----Original Message-----
From: Christian Rehberger [mailto:user-612b35aa5f4b@xymon.invalid] Sent: 22 September 2006 12:35
To: user-ae9b8668bcde@xymon.invalid
Subject: [hobbit] How to configure Clients
Hello,
I'm using hobbit since mondy this week and now I run in problems how to configure various checks on various clients.
Ok, I built a hobit server sucsessfully. The network tests works all fine.
But now I have to check disk space and procs on two other machines.
I've installed the client on each machine but I cannot configure the warnlevel or paniclevel of these clients or procs at all.
It seems, that only entries in the server located file "hobbit-clients.cfg" takes care?
My problem is, that I have to use different levels on each client machine!
Whats wrong with my configuration?
Thankx
Chris
--
Christian Rehberger
System Consultant · OCLC PICA GmbH
Grünwalder Weg 28g · 82041 Oberhaching · Germany
t +49-(0)89-61308 333 · f +49-(0)89-61308 399 e user-612b35aa5f4b@xymon.invalid · w http://www.oclcpica.org