The documentation (in-file comments and man page) indicates the NOTICE
keyword in an alerts.cfg rule will produce an alert "if the message is a
'notify' message (typically sent when a status is enabled or disabled)."
notifications.log shows the e-mail going out when a monitor is disabled,
but not when enabled, either through a manual enable or through a disable
timeout. Is this expected/intended behavior? How do I get alerts for both
disable and enable?
Xymon 4.3.12
--
*Steve Coile*Senior Network and Systems Engineer, McClatchy Interactive
<http://www.mcclatchyinteractive.com/>;
Office: XXX-XXX-XXXX | Mobile: XXX-XXX-XXXX | Fax: XXX-XXX-XXXX