I think white typically show up for tests that are dependent on some other
test. For example, the network tests do that. I've recently had some ping
failures, so ssh came up white, but the client tests (cpu, memory,disk,
ports, procs) all came through OK.
Ralph Mitchell
On Mon, Sep 17, 2012 at 6:41 AM, John Horne <user-e95f1ec2f147@xymon.invalid>wrote:
Hello,
Using Xymon 4.3.10, we had a problem with a client sending an oversize
message. This caused the 'procs' test to show purple, but it also caused
the 'files' test to show as white.
We have sorted out the oversize message bit, but I am concerned that
because a test showed white we were unaware of it because it doesn't
show on the 'non-green' page. (We were only aware of it because of the
purple 'procs' test and then looking at the 'Current status' page to see
all the tests for the client.)
Is there a way to report a test as purple if it changes from a colour to
white?
I'm not sure why it reported white and not purple. The status report
from the client was truncated, and I assume the 'files' test, therefore,
received no status.
Thanks,
John.
--
John Horne Tel: +XX (X)XXXX XXXXXX
Plymouth University, UK Fax: +XX (X)XXXX XXXXXX