On Thu, May 21, 2015 9:13 am, Mark Felder wrote:
On Thu, May 21, 2015, at 11:11, Asif Iqbal wrote:
On Thu, May 21, 2015 at 11:46 AM, Mark Felder <user-db141d317836@xymon.invalid> wrote:
On Thu, May 21, 2015, at 10:20, Asif Iqbal wrote:
On Thu, May 21, 2015 at 10:51 AM, Root, Paul T
<user-76fdb6883669@xymon.invalid>
wrote:
So really dumb question here. Did you restart apache after
removing
4.3.17 and installing 4.3.20?
Yep, few times.
Ok, so ScriptAlias is from mod_alias, but that doesn't mean cgi
binaries
are actually going to work.
Is mod_cgi actually loaded?
apachectl -t -D DUMP_MODULES | grep cgi
cgi module was not present. I just installed it and now most of the
column
works! Thanks a lot!
I still get the content of the binary for the following columns. rest
are
good now
bbd
memory
xymond
xymonnet
I also restored svcstatus.sh from hardlink to symlink and removed the
two
SetHandler lines
Still all the columns now working except the above four. Until I had the
cgi module installed
none of the columns were working.
Thanks Mark for taking it very close to completely working!
They're all calling svcstatus.sh, so I am guessing you have a browser
cache issue.
Nice deductions! :) This seems like a good candidate for adding to the
FAQ/known docs -- especially if it's not always typical to have mod_cgi
present and loaded in some distros.
I also restored svcstatus.sh from hardlink to symlink and removed the
two
So just to confirm: the config still works when the .sh files are
hardlinked as well? (And without FollowSymLinks?) If there's any issue
there, I'd like to get a fix into the install scripts before releasing a
4.3.21 update.
Regards,
-jc