Hi William,
all you have to do is including your switches in the bb-hosts, with a
line like this:
<ip> <host> # DEVMON
Then, run "devmon --readbbhosts", and the devmon process will start
polling the switch.
HTH,
Harald
William Ottley schrieb:
Well we have a few 2600's, and an ASA5500 that I'd like to grab info from,
such as up time, bandwidth usage, etc....
I saw that there is a template for cisco ASA so I'm hoping its for that
machine.
I'm new at this, and just trying to figure out what "switches" I have to put
into the bb-hosts files...
(still haven't figured out what area to change: bb-hosts or the client
config files)...
On 19/03/09 9:38 AM, "McDonald, Dan" <user-290ce4e24e19@xymon.invalid> wrote:
On Wed, 2009-03-18 at 12:29 -0400, William Ottley wrote:
Is there a Cisco monitoring script that I could use?
Although you will hear many calls for devmon, devmon does not currently
support snmp v3. If that is a requirement for you, then I would
recommend using mrtg with appropriate templates, and bbmrtg.pl to report
the values to xymon. I use that technique to monitor 135 UPS, 94
temperature/humidity probes, 19 firewalls, and close to 300 Cisco
routers/switches.
--
Harald Husemann
Netzwerk- und Systemadministrator
Operation Management Center (OMC)
MATERNA GmbH
Information & Communications
Westfalendamm 98
44141 Dortmund
Geschäftsführer: Dr. Winfried Materna, Helmut an de Meulen, Ralph Hartwig
Amtsgericht Dortmund HRB 5839
Tel: +XX XXX XXXX XXX
Fax: +XX XXX XXXX XXX
www.annyway.com <http://www.annyway.com/>;
www.materna.com <http://www.materna.com/>;