On Wed, Mar 13, 2013 at 7:13 AM, Nick Pettefar <user-2027539dd102@xymon.invalid> wrote:
I have an xymon client for a NAS but the NAS is connected via another
xymon client and is not reachable from the xymon server. How would I
set this up in the xymon server configuration - does it need a
hosts.cfg entry and if so, what would it look like? On the client, do
I give it the address of the xymon client running xymonproxy or the
actual server?
Regards,
Nick Pettefar
If I understand your situation correctly: turn the server with connection to
the main xymon server into a proxy and point the NAS to that proxy. I
believe you would have to install the xymon server there (to provide the
xymonproxy utility) turn off everything you don't need in tasks.cfg and turn
on xymonproxy. The comments are good in the file about how to do this. You
may have to use the arg to xymonproxy to tell it to listen to a different ip
than the standard one if the server is dual homed and the NAS is on, say, a
private network.
I'm not sure if the proxy needs hosts.cfg. On my proxy it already does
because it was private network tester before it was a proxy.
HTH
Steve
Purdue
--
If they give you ruled paper, write the other way. -Juan Ramon Jimenez,
poet, Nobel Prize in literature (1881-1958)
I prayed for freedom for twenty years, but received no answer until I prayed
with my legs. -Frederick Douglass, Former slave, abolitionist, editor, and
orator (1817-1895)