On 20-09-2011 22:40, Tom Diehl wrote:
I just upgraded from 4.3.4 to 4.3.5 and I am getting errors that I do not
understand. I would appreciate it if someone could tell me what to look
at to
correct the errors in the following log snippets:
==> xymonlaunch.log <==
2011-09-20 16:06:59 xymonlaunch starting
2011-09-20 16:06:59 Loading tasklist configuration from
/usr/lib/xymon/server/etc/tasks.cfg
2011-09-20 16:06:59 Loading hostnames
2011-09-20 16:06:59 Cannot load host data
This one puzzles me a bit. Supposedly it comes from xymond while
starting up, but xymond should not have problems loading hosts.cfg.
==> xymongen.log <==
2011-09-20 16:07:04 xymond status-board not available, code 0
2011-09-20 16:07:04 Failed to load current Xymon status, aborting
page-update
This is not unusual when Xymon starts. It happens because xymongen (the
tool that generates the static overview webpages) tries to fetch the
current status from xymond before it is ready (e.g. because it is
loading the saved state).
It will run again one minute later and work normally.
==> history.log <==
2011-09-20 16:07:51 Peer not up, flushing message queue
==> rrd-status.log <==
2011-09-20 16:07:51 Peer not up, flushing message queue
These are normal. xymond_channel doesn't start the various worker
modules (xymond_rrd, xymond_history etc.) until the first message
arrives, and when that happens it will log this message.
==> xymond.log <==
2011-09-20 16:07:51 Whoops ! Failed to send message (timeout)
2011-09-20 16:07:51 ->
2011-09-20 16:07:51 -> Recipient '192.168.0.2', timeout 15
2011-09-20 16:07:51 -> 1st line: 'config hosts.cfg'
2011-09-20 16:07:51 Cannot load hosts.cfg from xymond, code 7
2011-09-20 16:07:51 Failed to load from xymond, reverting to file-load
This could be the same core problem as the first log message you've shown.
Are you by any chance running xymond with the "--no-download" option? Or
do you have a "--admin-senders" option enabled for xymond ?
In addition, restarting xymon clears all of the acks and disabled hosts.
I can reset them without problem but I do not understand why they are
getting deleted.
They shouldn't be, but right now I cannot determine if this is a result
of the problems with loading the hosts.cfg file.
Could you try changing lib/loadhosts_file.c: Lines 140-144 look like this:
prepresult = prepare_fromnet();
if (prepresult == -1) {
errprintf("Failed to load from xymond, reverting to file-load\n");
prepresult = prepare_fromfile(xgetenv("HOSTSCFG"), extrainclude);
}
Change them to just
prepresult = prepare_fromfile(xgetenv("HOSTSCFG"), extrainclude);
Then do a "make clean; make; make install".
Regards,
Henrik