You seem to have $XYMONHOME defined as "." rather than the full path to the
directory.
On 13 September 2012 22:52, Kemi Ariyo <user-48420a703cc4@xymon.invalid> wrote:
Hello,****
I am trying to configure my xymon client 4.3.10 to local mode i.e. allow
client to do the proc check locally and I keep getting this error****
** **
bin/xymonclient.sh: ./bin/xymond_client: not found****
** **
Can anybody please assist****
** **
Thank you****
** **
*Kemi Ariyo*
*IS Solutions plc*
*Switchboard: 01932-893333*
*Direct: 01932-893327*
*Fax: XXXXX-XXXXXX*
*Mobile: *
*http://www.issolutions.co.uk*
** **
Disclaimer:
This message is intended for the addressee only. It may contain
information of a confidential or legally privileged nature. If you have
received this message in error please notify the sender and destroy the
message immediately. All attachments have been scanned for viruses. However
IS Solutions plc cannot accept liability for any loss or damage you may
incur as a result of virus infection.