xymon-rclient

On 07/08/14 00:39, Jeremy Laidman wrote:

I'd put this in a script like so:

#!/bin/sh

TESTNAME="foo"
REGEX="some regex"

do_fetch() {
    wget ... --header="SOAPAction: 
\"http://$1/ComprehensivePersonSearch\"; -O - http://$2/BobService.asmx
}

$BBHOME/bin/bbhostgrep foo | while read IP HOSTNAME OTHER; do
    if do_fetch $HOSTNAME $IP | grep "$REGEX" > /dev/null ; then
        COL=green
        MSG="Test for $TESTNAME is OK"
    else
        COL=red
        MSG="Test for $TESTNAME failed"
    fi
    $BB $BBDISP "status $HOSTNAME.$TESTNAME $COL `date` $MSG"
done

This is from memory and hasn't been tested, but should give you the gist.

Just a thought, couldn't this have used the cont check?

In any case, to explain the script to the OP, this line:
     $BB $BBDISP "status $HOSTNAME.$TESTNAME $COL `date` $MSG"

The HOSTNAME value is taken from the xymon hosts file, and used to tell 
xymon where to place the colored dot with this result.

Also, perhaps the following changes would be helpful:

     if do_fetch $HOSTNAME $IP | grep "$REGEX" > /dev/null ; then

result=`do_fetch $HOSTNAME $IP`
if `echo "$result" | grep -q "$REGEX"`; then
         COL=green
         MSG="Test for $TESTNAME is OK

$result"
     else
         COL=red
         MSG="Test for $TESTNAME failed

$result"
fi

This may be useful to know what the actual value was when you got an 
error, or even what the actual value was when it changed from non-green 
to green. Of course, if $result is a large amount of data, then you may 
not want to display the full value, you can pass it through grep or 
other tools to reduce it down to a smaller/more useful amount of data.

Note, the above hasn't been tested at all, so watch for syntax or other 
errors, but hopefully it will be useful.

Regards,
Adam

-- 
Adam Goryachev Website Managers www.websitemanagers.com.au