From the man page: "The entire file is evaluated from the top to bottom,
and the first match found is used. So you should put the specific settings
first, and the generic ones last."
The DEFAULT section should be the LAST section, and the Powershell above it.
Tim
On Thu, May 23, 2019 at 11:22 AM Jaime Kikpole <user-c575ba5bb612@xymon.invalid>
wrote:
I had no idea that was a possibility. I love the approach.
Unfortunately, it doesn't seem to be working. I put your example (sans
"DISK") in my analysis.cfg file just below the DEFAULT section and above
the first HOST=... section. Then I ran three YouTube videos to force the
load above 10% for a while. The alert went red.
Based on some online research, I added "CLASS:powershell" to the end of
that host's line in hosts.cfg. Then I waited a bit over 5 minutes. The
alert stayed red.
Is there a way to see what class a host is reporting in as?
Is there an easier way to see if the desired settings are applying to the
host than waiting 5 minutes to see if the alarm changes?
Jaime Kikpole
Director of Technology & Innovations
Cairo-Durham Central School District
(XXX) XXX-XXXX, x59500
cairodurham.org <http://www.cairodurham.org>;
Technical Support:
user-2eed5d3dd752@xymon.invalid
go.cairodurham.org/techtips
[image: Google Certified Educator, Level 1] [image: Google Certified
Educator, Level 2]
This electronic message and any attachment(s) may contain confidential or
legally privileged information protected by law from further disclosure and
is intended only for the individual or entity identified above as the
addressee. If you are not the addressee (or the employee or agency
responsible to deliver it to the addressee), or if this message has been
addressed to you in error, you are hereby notified that you may not copy,
forward, disclose or use any part of this message or any attachment(s).
Please notify the sender immediately by return email or telephone and
permanently delete this message and attachment(s) from your system.