Hi, any news about the errors below ?
I've got the same errors :-(
Latest error messages:
Loading hostnames
Cannot load host data
Loading saved state
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Too few fields in record - found 6, expected 17
Setting up network listener on 0.0.0.0:1984
Setting up signal handlers
Setting up xymond channels
Setting up logfiles
Setup complete
Whoops ! Failed to send message (timeout)
->
-> Recipient 'XXX.XXX.XXX.XXX', timeout 15
-> 1st line: 'config hosts.cfg'
Cannot load hosts.cfg from xymond, code 7
Failed to load from xymond, reverting to file-load
It will run again one minute later and work normally.
.. me too ?!
cheers,
martin
On Wed, 21 Sep 2011, Henrik Størner wrote:
On 20-09-2011 22:40, Tom Diehl wrote:
I just upgraded from 4.3.4 to 4.3.5 and I am getting errors that I do not
understand. I would appreciate it if someone could tell me what to look
at to
correct the errors in the following log snippets:
==> xymonlaunch.log <==
2011-09-20 16:06:59 xymonlaunch starting
2011-09-20 16:06:59 Loading tasklist configuration from
/usr/lib/xymon/server/etc/tasks.cfg
2011-09-20 16:06:59 Loading hostnames
2011-09-20 16:06:59 Cannot load host data
This one puzzles me a bit. Supposedly it comes from xymond while starting up,
but xymond should not have problems loading hosts.cfg.
==> xymongen.log <==
2011-09-20 16:07:04 xymond status-board not available, code 0
2011-09-20 16:07:04 Failed to load current Xymon status, aborting
page-update
This is not unusual when Xymon starts. It happens because xymongen (the tool
that generates the static overview webpages) tries to fetch the current
status from xymond before it is ready (e.g. because it is loading the saved
state).
It will run again one minute later and work normally.